This large size powder coating oven is designed for longer workparts, such as aluminum profiles, metal door, frames, iron fence and gates, etc. It is recommended for heating by gas or diesel, as it is much more ecnomical and ensures a superior productivity in comparison with the electrical curing oven.
The transport system includes trolleys and top conveyor for your multi application. the parts will be adequately heated as the polymerization temperature will maintain until the end of the cycle. The curing time and temperature are set up for each type of powder coating and controlled by the oven's PLC controller.
1. Wallboard panel - Rockwool insulation board, 100 mm thickness, density 120kgs/cbm. Outside is colorful steel, inside is gavalnized steel, anti-flame and heat-insulation.
2. Working door - two sets of doors(go through type) for in and out.
3. Heating System - Gas burner * 1unit - 15~20 minutes reaching the baking temperature 180-200°C
4. Air circulation System- One set of heat resistant fan for circulating the hot air, one set of cooling pump for cooling the axle bearing.
5. E-control Panel - 1unit, including automatic/constant temprature, stop, emergency stop, start, oven temperature setting, constant temperature setting, hot air temperature setting, over indicator, failure indicator, normal indicator, power indicator, pre-work indicator.
|Operating Dimension||Width1900 x Height1900 x Depth500 mm|
|Burner||Italy Riello, 200,000cal|
|Voltage/Frequency||220V/280V/415V, 50/60Hz (voltage can be custom as local)|
|Warm-up Time||15-30min (180°C)|
|Temperature Stability||<± 3-5°C|
|Circulation/Air Flow||Vertical, Varaible through holes on the walls|