|Payment & Shipping Terms||Supply Capacity|
|Unit Price:||2000.0 USD||Packing:||wood box or carton box|
|Trade Term:||FOB||Delivery Date:||15days|
|Min. Order:||1 Piece/Pieces|
|Means of Transport:||Ocean, Air|
after spraying the part, the polymerization of the applied powder coating can be done by heating it in a paint polymerization oven that runs on gas.
Specific to this type of equipment is the use of a blast-lamp to heat the oven. The blast-lamp can work on gas or GPL, even on diesel.
automatization panel through a digital temperature controller.
The conveyorized part will be adequately heated to the used powder's thermal condition and will be maintained at the polymerization temperature until the end of the manufacturing cycle.
In comparison with the electrical polymerization oven, the gas heating is much more echonomical and insures a superior productivity.
The polymerization time and temperature are set up for each type of powder coating and are controlled by the oven's thermoregulator and timer.
The shown oven is manual, stationary, with two doors, runned manually or mechanically.
The inner dimensions of the oven can be made on command from our customers, but the most used ones are:
Inner length = 4.000 mm;
Inner width = 1.100 mm;
Inner height = 2.000 mm;
1. Wallboard panel
- Rockwool steel colorful board, 100 mm thick, density 120kgs/cbm.Outside is colorful steel,inside is gavalnized steel, anti-flame and heat-insulation.
2. Working door
- two sets of doors(go through type) for in and out,with lock lift.
3. Heating System
- Gas burner * 1unit
- 15~20 minutes reaching the baking temperature 180-200°C
- Cabinet (rock wool insulation) for the burner & heat chamber* 1unit
4. Air circulation System
One set ofheat resistant fan for circulating the hot air,one set of cooling pump for cooling the axle bearing.380v/50hz/3phase.(other voltage required need to add 150USD)
5. E-control Panel
- *1unit, including automatic/constant temprature,stop,emergency stop,start,oven temperature setting,constant temperature setting,hot air temperature setting,over indicator,failure indicator,normal indicator,power indicator,pre-work indicator.
1 set of guide rail for pushing the trolley in and out.
- All Hardware, Fasteners, and Sealants
The trolley and water box should be made by the customers themselves.If you want to custom made by us,pls give us the drawing.
Category: Powder Coating Gas Oven